MicroJig MATCHFIT CNC Work Holding Clamp Kit*

*Final sale.

Virtually all CNC machines sold come with two simple hold-down clamps, if any at all, leaving you to figure out how to hold your parts securely and confidently. Say goodbye to the days of makeshift jigs, the aggravation of incompatible hardware, and the frustration of imprecise holds. Whether crafting a delicate inlay, engraving a custom piece, or producing repeat parts for a client, the MATCHFIT CNC Clamping Kit turns your workshop into a haven of efficiency.

The ingenious low-profile design of the Workholding Kit elevates your woodworking without getting in the way of your tools. It is the only clamping system that uses the MATCHFIT Dovetail System to securely hold stock while you work the top on your CNC, clamping table, jig, or fixture.

When work needs to be done across the part surface, it must be held by the edges to prevent damage to the clamps and bits. Clamps holding stock from the top is the most common holding method, and this system engages the work top and edge to prevent movement during heavy milling.

With MATCHFIT, you're not confined to pre-set clamp positions. Carve out your custom dovetail tracks on any wooden surface, enhancing your hold-down capabilities where you need them most. The Dovetail Track System gives you all the functionality of T-track, in less time and at a fraction of the cost.

All MatchFit clamps slide into any 1/2" x 14º dovetail groove, transforming your setup into a unified clamping haven for unmatched efficiency.