Pre-Color Easy is an optional pretreatment, designed to be used in combination with Oil Plus 2C, to create special complimentary and contrasting effects while allowing the optimal molecular bonding of Oil Plus 2C with the wood to remain guaranteed.
- Colors can be mixed.
- Unlimited creative possibilities.
ATTENTION: This product is a pre-treatment and does not protect the wood. It has to be combined with Rubio Monocoat finishing products for maximum protection.
Note: Color swatches are shown on White Oak. Due to the many variations in monitors settings, actual color may slightly vary.
[TABS]
Specs
Spread Rate: 15-20 sq. ft.
Dry Time: Varies. Test with a moisture meter before and after to ensure full dry.
Dilutable: With Water
Shelf Life: 12 months
Warning: Do not allow to freeze
Directions
1. Sand the surface according to professional standards. When renovating old floors, you must remove all the residues from previous treatments completely (varnish, oil, wax, etc.).
2. Vacuum the floor with an industrial cleaner, then apply RMC Cleaner.
3. Stir the product thoroughly and regularly with a stirring rod.
Manual application:
• Work in areas sized to allow manual touch-ups without having to tread the finished area. If necessary, use tape to tape off areas.
• Apply RMC Precolor Easy in crosswise direction using a (mohair) roller.
• Spread evenly using a lint-free cloth.
Mechanical application:
• Work in areas sized to allow manual touch-ups without having to tread the finished area. If necessary, use tape to tape off areas.
• Apply RMC Precolor Easy in crosswise direction using a (mohair) roller.
• Polish using a floor polisher with a red RMC Pad. As soon as circles are no longer visible, stop polishing (do not rub dry).
• Now, rub the borders evenly using a scrubby and a red RMC Pad.
4. Allow the surface to dry for 1 to 3 hours. The exact drying time depends on the foundation, moistening, temperature and ventilation.
For any overlapping: see remarks!
5. Apply the RMC Oil Plus 2C. Please consult the technical data sheet of the oil for
the correct application of this product!
Remarks:
- Any overlapping can be removed! Spray clean water on the floor and polish with a polisher or scrubby with a red RMC Pad.
- Any overlapping WILL NOT be removed when applying the oil. It is important to remove any overlapping areas before applying the oil.
- If any wood fibres are still upright, you will need to grind these using a floor polisher equipped with a beige pad. Afterwards, vacuum thoroughly.
Advice:
- Switch off the floor heating 48 hours before application.
- Do not use in combination with water based finishing products!
- Do not apply as a covering or film-forming lay
[/TABS]
